Home > Ice Maker > Ge Refrigerator Ice Maker Not Getting Water

Ge Refrigerator Ice Maker Not Getting Water

Contents

The drip pan is directly behind these wires and warm moist air is being blown directly over these wires every time the defrost fan comes on. Your model number is on a plate, in one of these locations: Side by Side Freezer on Top Handy tip -Make it easy on yourself! Reply jIM hOISINGTON January 31, 2014 at 4:37 pm I have a GE side by side refridg that the water was always freezing up and I would take the hair Help! Check This Out

Any suggestions in how to fix this or do I need a new ice maker? Forty two hours later (thus, nearly 2 days) - - and voila' - I now have water dispensing again. If the mold thermostat is defective, the ice maker will stop making ice. Parts Water Filter Please enter your model number so we can show you the part that fits your exact model Where is my model number? http://www.geappliances.com/ge/service-and-support/refrigerators-freezers.htm

Ge Refrigerator Ice Maker Not Getting Water

Your model number is on a plate, in one of these locations: Side by Side Freezer on Top Handy tip -Make it easy on yourself! Everything works great. Or check out the related posts where we list some possibilities for your issue.

Could you help me? While you're in there it's a good time to replace the small thermostat sensor too but this is not required. Cause 10 Icemaker Switch The ice maker switch might be defective. Ice Maker Not Making Ice Frigidaire The water flow reduced recently.

I tried the hair dryer trick and leaving freezer door open for an hour cause thought was froze up,still no ice and need it for the whiskey! Ge Refrigerator Ice Maker On Off Switch I do love your videos, I am a 62 year old woman and get very pleased with myself when I can fix a problem by following the videos made by people My dispenser lights are not working. Eventually, this method stopped working.

Top 5 Reasons Refrigerator Is Freezing Food? Ge Profile Refrigerator Ice Maker Problems French Door Reply Suzi August 22, 2013 at 8:46 am I just replaced the water filter but when I first put it on I forgot to fill it with water before installing it. Since many of the ice maker components are not sold separately, you may need to purchase and replace the entire ice maker assembly. Replacing or installing a heater was more than I wanted to do.

Ge Refrigerator Ice Maker On Off Switch

Enter your model number: Need help finding your model number? When the ice drawer fills with ice, it will raise the wire, shutting off the icemaker. Ge Refrigerator Ice Maker Not Getting Water Remove the ice bin from the refrigerator and remove any loose ice from the ice maker. 2Find the fill tube. Ge Ice Maker Parts Checked freezer drainage and found no ice formation.

How do I get it out? http://pfntech.com/ice-maker/ge-refrigerator-ice-maker-not-working.html If you use one of those clamp on saddle valves they are notorious for restricting flow. Reply MIKE HEARN June 24, 2014 at 9:59 pm BOB. At this moment My Dispenser console is not lighting up at all. Ge Under Counter Ice Maker

That black square thing that surrounds it how do I get it off with out destroying it. Reply Margaret September 3, 2013 at 10:19 pm I LOVE YOU, Handyguys. Tried hair dryer-no luck. this contact form Its very odd as the freezer is working fine and the water freezes as it passes through the freezer.

ET Apply to become an Authorized GE Appliances Servicer Contact Us Major Appliance Questions 1-800-626-2005 GE Appliances Answer Center Monday–Friday: 8 a.m.–10 p.m. Ge Ice Maker Kit I decided to wait another hour. Could this be an electronic issue?

When you put the bin back in, make sure that the bar goes into the stirrup, not under it.

Might have been a combination of both. Please and thanks so much. The filter could be inline or built in to te frige. Ge Bottom Freezer Refrigerator Ice Maker Problems Reply Jonathan July 14, 2016 at 6:30 pm One of the GE water tube heaters I installed also failed within a few weeks.

Reply Verity Lawrence September 3, 2014 at 12:37 pm Oh I was ever hopeful :0( back to the drawing board then I guess..if I find a solution will let you know Reply The Handyguys October 31, 2013 at 2:06 pm Perhaps there is a buildup of ice on the mechanism. Reply Addie June 28, 2014 at 7:06 pm Unfortunately that wasn't the problem. navigate here If not, any further troubleshooting advice would be awesome!

Reply The Handyguys December 27, 2012 at 9:42 am Thanks for the tips Bob - We agree that soldering the connections is more robust but not everyone possesses the tools or If the screen is plugged, water flow will be restricted and the result will be small or layered ice cubes. Thanks! Can you post a tutorial on changing the filter?